Electrodepot
 
 
1 Channel Remote Control Digital Control KIT
 
Application EXAMPLES  DISCLAIMER
Complete system with single channel Transmitter and Receiver for 2 Miles of Line-of-Sight range Up to 10 Miles with optional Long Range Antenna
Over 64,000 Codes, Weather-Resistant Case, Power On and RF Activity Indicators

 

937200   $999.99 

 Included:

7101 Single channel transmitter $299.99
7001 Single channel receiver $299.99
8" Antenna w connector $39.99 x 2 = $79.98
4135b Single shot relay $89.99
4135 Toggle relay   $89.99
Power adapter 12VDC $29.99 x 2 = $59.98
Float switch $69.99 x 2 = 139.98
 

Select extra Transmitter

SPECIFICATIONS
Output  N/0 and N/C relay 1 Amp @ 32 VDC isolated  contacts
Operating Voltage: 12 to 15.o VDC
Operating Temperature: -4° to +140° F (-20° to +60° C)
Receiver Type:  Digital Superheterodyne
Sensitivity:  -118 dB (minimum)
 Selectivity 6 KHz
Carrier Frequency 27,255 MHz
Number of Codes: 65,536
Code Setting Method  DIP switch programming
Data Input Alarm, restore, status, and low battery
Status Exception Time Frame: Four hours
Antenna Impedance 50 Ohms Quarter Wave Antenna optional
Dimensions: 4.25 in L x 2.5 in W x 6.25 in H (108 x 64 x 159 mm)
Weight 1 lb. (0.454 Kg)
Current Drain 25 mA, typical standby 65 mA alarm @ 12 VDC
Outputs: Alarm  form "C" relay per channel  
Status exception one open collector output per receiver;   
Low Battery one open  collector output 50 mA @ 20 VDC to ground

Optional: Power relay   Latch relay   

Wiring Diagram

.

DISCLAIMER: The applications shown here are referential help examples and ideas only, and are not intended for actual constructions plans
Contact a licensed professional for your final project. Electrodepot assumes no responsibility of the use of this  drawings

Warning: Radio control equipment is not to be used in life safety