Electrodepot


 Wireless carbon monoxide sensors  CO  alarm Kit

 

937125

   $1789.99 

Kit Includes:

CO sensor 930450
Transmitter panel
Receiver panel
2 Whip antennas
2 Power adapters
Wiring Diagram

Special Order item

 

Complete system with single channel Transmitter and Receiver for 2 Miles of Line-of-Sight range Up to 10 Miles with optional Long Range Antenna
Over 64,000 Codes, Weather-Resistant Case, Power On and RF Activity Indicators

CO Sensor


 Visual display:

GREEN - Normal operation.
FLASHING AMBER - Trouble Contact installer 
RED - Danger! Move to fresh air
 (hazardous condition is present.)

Transmitter

Transmitter Input
Single shot relay
Wiring terminal		   Receiver

Receiver Control Output
Relay Output 10 Amp @250 VAC
Reset Button

Operation:  Upon the alarm signal from the 930450 CO sensor the transmitter is triggered, and sends a pulse signal, The receiver energizes a latch relay, the output from this relay includes NO and NC contacts to be used to activate lights or alarm buzzer, a reset button is included to rearm the system
Wiring diagram is included with each kit.  Power adapter 120/220VAC input,  NEMA 4X enclosure

Radio Control System
SPECIFICATIONS
Operating Voltage: 12 to 15. VDC
Operating Temperature: -4° to +140° F (-20° to +60° C)
Receiver Type:  Digital Superheterodyne -118 dB 
Carrier Frequency  27,255 MHz
Number of Codes:  65,536 DIP switch programming
Current Drain 25 mA, standby 65 mA RX ,  2 Amp TX
Data Input TX  Dry contact 
Relay Output 10 Amp max 30VDC -  250VAC N/0 and N/C
Antenna Impedance 50 Ohms Quarter Wave Antenna optional
Dimensions: 10 in L x 8 in W x 4 in H (254 x 200 x 100 mm)
Weight 4 lb. (2 Kg) each
Enclosure NEMA 4X non metallic waterproof

Enclosure NEMA 4X  Fiberglass
  • SENSOR Specifications
  • SPDT alarm relay
  • LED for operating status
  • 12-24 VDC / 13-24 VAC Input
  • Flush or surface mount
  • Long life sensor
  • All units individually calibrated
  • Listed to UL Standard 2075 for carbon monoxide detectors.
  • Tested to UL Standard 2034 for carbon monoxide detectors.
  • Surface mounts to a wall over a single gang electrical box.
  • CM-15 Voltage: 12-24 VDC or 13-24 VAC (50-60 Hz)  
    SPDT Alarm Relay Current (standby): 45 ma @ 12V, 31 ma @ 24V  
    SPST Trouble Relay Current (alarm): 62 ma @ 12V, 45 ma @ 24V

      CO Sensor additional specifications